01
Base prep on clay
We moisture-condition, compact, and grade the base over Blackland clay so the load spreads evenly and the pad doesn't rise or settle as the soil drinks in and gives up water beneath it.
Proof
A job we'd put our name on
A pad sized to what it has to hold, reinforced for the weight on top and based for the shrink-swell clay below, so it stays put without lifting or sinking on a settled Arlington lot.
Credibility comes from how it's built, not from promises. Here's the order of operations on every concrete pads & slabs job.
We moisture-condition, compact, and grade the base over Blackland clay so the load spreads evenly and the pad doesn't rise or settle as the soil drinks in and gives up water beneath it.
Thickness follows whatever ends up on the pad. A shed footprint and a shop floor under vehicles are nowhere near the same pour.
Reinforcement is matched to the job, from mesh on light pads up to a rebar grid for heavy loads and for spanning movement in our expansive ground.
Beneath an enclosed or finished pad we roll out a vapor barrier so dampness in the ground stays below and can't migrate up into the slab.
We set a well-proportioned mix, saw the control joints, and run a cure schedule that keeps the afternoon heat from drawing the strength back out of the top.
Most contractors vanish after the deposit. We pick up the phone, show up when we say, and stand behind the work after the truck leaves. The follow-through is the difference.
A foreman we know runs your job and a vetted crew does the work, managed by Lucky's, one company accountable from the first call to the final walkthrough.
COI and lien waivers on file before we break ground. The documentation that lets commercial clients pay and gives homeowners peace of mind.
Prepped subgrade, reinforced and mixed to spec for the job, and proper curing. We build credibility through the process, not promises. On concrete pads & slabs, that starts with base prep on clay.
A pad in North Texas takes its price from the load and the dirt under it: reinforcement matched to the use, a compacted base over expansive clay, and a cure that holds against the summer sun. A fair starting range puts most pads and slabs at about $7 to $13 per square foot, shifting with thickness and whether a vapor barrier belongs in the build. We size and price each one against the weight it will end up carrying.
The load decides it. A shed pad asks far less than a garage or shop floor parked under trucks and gear, so we tune the thickness and the steel to your actual use and to the expansive clay sitting underneath.
Yes. Both are heavy and concentrate weight on a few points, so we thicken the pour and add steel. A hot tub in particular wants a flat, dependable base that won't tilt or drop as the clay works, which makes the groundwork count just as much as the slab on top. Give us the equipment and we build the pad around it.
For an enclosed or finished slab, usually yes; the barrier stops ground dampness from working its way up through the concrete. We decide it case by case off of what the slab is meant to do.
Some do, depending on the size, the spot, and the purpose, and one Mid-Cities town's rules don't always match the next. We call out when a permit looks likely so it gets sorted before the pour rather than after.
A slab keeps building strength well after the surface looks finished. We hand you a definite date to set equipment on your specific pour, with the week's heat factored in.
You'll hear back from a real person, usually the same day. No call center, no runaround, no chasing us down.
Booking up fast this season. Or call (737) 258-4735